Winchester 1897 Action Slide Hook Screw The Smith Shop
Made from the finest grain S-7 Tool Steel which is high impact tool steel used in the die stamping industry. The screws are professionally Heat Treated and Tempered to a Rc 44-46 hardness for extreme toughness.
If you want to protect your cowboy Winchester ‘97 shotgun from costly repairs which could result in the loss of your bolt and quite possibly an ugly hole in the side of your gun’s receiver, the two seconds it takes you to replace the Action Slide Hook Screw with the new super-tough Smith Shop screw is the answer. The original Slide Hook Screw is very susceptible to premature breakage. The Smith Shop screw is made of high impact resistant S-7 tool steel and is properly hardened and tempered. Be sure to use the new Action Slide Hook Screw from The Smith Shop to avoid this potential problem.
Every Wild Bunch or Cowboy Action 1897 should have one of these installed. The original will break over time and when they do they are very hard to get out and sometimes the frame has to be drilled to remove them. I am putting these in all of my 1897’s.
Warning: A competent gunsmith only should install these parts. All products are sold as is and without any warranty. No liability is expressed or implied for damage or injury which may result from the improper installation or use of these products.